Ss-cycle Closed Loop Oxygen Sensor Kit for Delphi Style S&a Manual de usuario Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 8
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
5
10- Continue running the S&S® wiring harness so the four wire ends are directly next to the 36-position ECM connector and fuse block area. Cut
the wire tie at the base of the main wiring harness where it meets with the 36-position gray connector. See Picture 7, below.
11- Carefully open the backside of the 36-position connector housing. See Picture 8, below.
12- Gently release the clips on each side of the clear plastic cover on the 36-position connector by pressing on each clip with a small at
screwdriver as shown in Picture 9, below.
Picture 7
Picture 8
Picture 9
Vista de pagina 4
1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios